SS316 Steam Vortex Flow Meter , Low Flow Flowmeter, with LCD
1) Measuring medium: Steam,gas, liquid
2) Accuracy:Liquid:1.0% Gas:1.5%
3) Repeatability:Liquid 0.33% Gas:0.5%
4) Range:Liquid:0.7m/s~7m/s Gas:7m/s~40m/s
5) Body material:304 stainless steel(SS316 is optional)
6) Power supply:24VDC(12VDC),Lithium battery
7) Relative humidity:5~95%
8) Protection level:IP65
9) Electrical connection:M20*1.5
10) Simple installation and easy maintenance
11) Wide measuring rang,the ratio is up to 10:1.
12) Low pressure loss and operating costs.
Design & installation
It is importannsttatoll install meter,if not installed well, then
would affect precision,
use-life and damage.
1． To avoid strong current, high frequency and powerful switch set,
of meter shall be avoided to near by these equipments.
2． To avoid high-Temp & radiation source. if have to install
it, need heat insulation
& ventilated measure.
3． To avoid high-Temp & etchant gas, if have to install it,
need ventilated measure.
4． vortex street flow meter shall be avoided to install on shaking
part of pipeline. if
have to install on it,shall add clamp device and vibration pad
which located on 2D
to enhance shake proof . meter has better to installed indoors, pay
attention to waterproof
when installing meter outdoors,special notice the joint, make cable
conductor to U
shape to avoid water get into the amplifier body Around installing
save enough space,so that install connection line and maintenance
The series of Vortex Flowmeter is based on Von Karman’s Vortex
Principle, which adopts
piezoelectric crystal as testing components. It is a new kind of
stress detecting vortex flow meter.
It has the advantages of wide range rate, high accuracy,low
pressure loss, good medium generality,
pulse signal output proportional to flow, convenient to connect
with computer etc.As the detector
probe of sensor and the vortex generating body are installed
separately, and the high temperature
resistant piezoelectric crystal does’t contact with medium, so the
instrument is of simple structure,
good generality, and high stability.
LUGB series Vortex Flowmeter sensor can be used to detect and
measure the flow of all kinds of gas,
fluid and steam.
LUGB flowmeter sensor can be used to match with our company’s
MT6000 series flow totalizer. It also
can match with computers and sensors of temperature, pressure, or
density to compose high-accuracy
mass flow or heat flow detecting and measuring system.